Bosch Plena Voice Alarm System - Page 6

6 en | Table of Contents Plena Voice Alarm System
9922 141 1037x (V2.16) | V0.6 | 2011.09 Installation and Operation manual Bosch Security Systems B.V.
6.3.5 Voice alarm router 71
6.3.6 Router ID 71
6.3.7 Termination switch 71
6.4 Call station 71
6.4.1 Call station ID 72
6.4.2 Sensitivity 72
6.4.3 Speech filter 72
6.4.4 Termination 72
6.5 Remote control 72
6.5.1 Remote control ID 72
6.5.2 Monitor 73
6.5.3 Termination switch 73
6.6 Remote control extension 73
6.6.1 Remote control extension ID 73
6.6.2 Termination switch 73
7Operation 74
7.1 Switch on 74
7.1.1 Voice alarm controller 74
7.1.2 Voice alarm router 74
7.1.3 Calibration 74
7.2 Background music 75
7.2.1 Select BGM source 75
7.2.2 Select zones 75
7.2.3 Adjust volume 76
7.2.4 Adjust frequencies 76
7.3 Business calls 76
7.3.1 Select zones 77
7.3.2 Make the announcement 77
7.4 Emergency state 78
7.4.1 Enter the emergency state 78
7.4.2 Acknowledge the emergency state 79
7.4.3 Exit the emergency state 79
7.4.4 Distribute live speech 79
7.4.5 Select zones 79
7.4.6 Make the announcement 80
7.4.7 Distribute the alert message 81
7.4.8 Distribute the alarm message 82
7.5 Fault State 83
7.5.1 Acknowledge the fault state 83
7.5.2 Reset the fault state 83
7.5.3 Fault indicators 84
8Troubleshooting 87
8.1 Introduction 87
8.2 Message or chime does not sound 87
8.3 No pilot tone detected on EOL board 87
8.4 No pilot tone detected on power amplifier 87
8.5 No BGM on the router 87