Plena Voice Alarm System Table of Contents | en 7
Bosch Security Systems B.V. Installation and Operation manual 9922 141 1037x (V2.16) | V0.6 | 2011.09
8.6 No BGM on controller or router 87
8.7 No sound coming from the router 88
8.8 Volume override only working for EMG, not for business calls (or similar problems) 88
8.9 False Ground Short fault 88
8.10 Start/Stop function on Trigger Inputs 88
8.11 Processor Reset 89
8.12 USB port not connected 89
8.13 Data fault during configuration upload 89
8.14 A click sounds through the loudspeakers at regular intervals 90
8.15 Password not working 90
8.16 Configuration download fails 90
8.17 Can’t retrieve the original wave files with the configuration download 90
9 Maintenance 92
9.1 Clean the units 92
9.2 Clean air inlets 92
9.3 Check the connectors and grounding 92
10 Technical data 93
10.1 Electrical 93
10.1.1 Voice Alarm Controller 93
10.1.2 Voice Alarm Router 95
10.1.3 Call Station 96
10.2 Physical characteristics 97
10.2.1 Voice Alarm Controller 97
10.2.2 Voice Alarm Router 97
10.2.3 Call Station 97
10.2.4 Call Station Keypad 97
10.2.5 Voice Alarm Remote Control 97
10.2.6 Voice Alarm Remote Control Kit 97
10.2.7 Remote Control Extension 97
10.2.8 Remote Control Extension Kit 98
10.2.9 Fireman’s Panel 98
10.2.10 End of line detection board 98
10.3 Environmental conditions 98
10.3.1 Voice Alarm Controller 98
10.3.2 Voice Alarm Router 98
10.3.3 Call Station 98
10.4 Standards 98
10.4.1 Voice Alarm Controller 98
A Appendices 99
A.1 Compliancy checklists 99
A.1.1 Emergency Sound Systems 99
A.1.2 EN60849: 1998 (valid for version 2.13.xx) 101
A.1.3 EN60849 - When using the Plena Remote Control Kits: 115
A.1.4 EN54-16 (valid for version 2.16.xx) 115
A.2 3.0 Hardware 160
A.2.1 Introduction 160
To Next Page
Loading...
