Plena Voice Alarm System Operation | en 77
Bosch Security Systems B.V. Installation and Operation manual 9922 141 1037x (V2.16) | V0.6 | 2011.09
7.3.1 Select zones
Select the zones to which the business call must be distributed with the zone selection
buttons on the call station or its keypads. A green LED indicates the zones to which the
business call is distributed.
– If the indicator of a button is off, the zone is not selected. Push the button to select the
zone.
– If the indicator of a button is on, the zone is selected. Push the button to deselect the
zone.
7.3.2 Make the announcement
Push the push-to-talk (PTT) button of the call station to make an announcement (see
Figure 7.7). The call is only distributed to the selected zones.
Figure 7.7 PTT button and indicators
The LEDs above the PTT button provide information about the status of the call station (see
Table 7.1).
Table 7.1 Call station status indicators
NOTICE!
The zone selection buttons of the call stations and call station keypads must be configured
with the configuration software.
NOTICE!
See the Configuration Software Manual (9922 141 1038x) for more information about the
configuration software.
Indicator Position Description
Yellow Left Busy
Green Center Talk
Red Right System in
emergency
state, call
station
disabled
To Next Page
Loading...
