Bosch Plena - Page 55

Bosch Security Systems | 2006-06 | 9922 141 10377 en
Plena Voice Alarm System | Installation and User Instructions | Equipment en | 55
15 Ground - A connection to electrically ground the
remote control.
16 Firmware upgrade connector - An RS232
connector to connect a PC to upgrade the firmware
of the remote control.
17 Firmware upgrade switch - A switch to upgrade
the firmware of the remote control.
18 Remote control extension sockets - Two
redundant RJ45 sockets to connect remote control
extensions to the remote control (see section 9.3.2).
19 Configuration settings - A set of DIP switches to
configure the remote control (see 22).
20 Controller socket - One RJ45 socket to connect
the remote control to the voice alarm controller
(LBB1990/00, see section 9.3.1).
21 Emergency microphone volume control - A
rotary knob to set the volume of the hand-held
emergency microphone.
figure 9.1: Front and rear views of the voice alarm remote control
0dB
-6dB
-20dB
Processor reset
Network
Call/EMG
Music/Spare
Ground short
Input
Mains
Battery
Zone1
Zone2
Zone3
Zone4
Zone5
Zone6
Alarm
Zone select
Plena Voice Alarm Remote Control
Fault Indicators
Zone select
Indicator test
EMG mic
Alert message
Alarm message
All call
Zone1 Zone2 Zone3 Zone4 Zone5 Zone6
Fault
EMG
Ack
Reset
A
B
Disabled
Message
EMG mic
RCP
Router
Design & Quality
The Netherlands
NL-4827HG-10
Plena Voice Alarm System
RC Panel
Max. input power
300mA, 24V DC
S/N.
PLN-V6RC
A03 5413
Made in China
N663
8900 199 60001
1
2 3 4 5
69121314
15171820
710
16192122232425
811