Bosch Plena - 10 LBB1998;00 Voice Alarm Remote Control Kit; Introduction; Overview; Installation

Bosch Security Systems | 2006-06 | 9922 141 10377 en
Plena Voice Alarm System | Installation and User Instructions | Equipment en | 58
10 LBB1998/00 Voice Alarm
Remote Control Kit
10.1 Introduction
With the LBB1998/00 Voice Alarm Remote Control
Kit, it is possible to make customized remote controls
that can be connected to the voice alarm controller. The
remote control kit provides the same functionality as the
LBB1996/00 Voice Alarm Remote Control.
10.2 Overview
See figure 10.1 for an overview of the front panel of the
remote control kit. The rear panel of the remote control
kit is the same as the rear panel of the LBB1996/00
Voice Alarm Remote Control (see figure 9.1).
10.3 Installation
The remote control kit is suitable for table-top and 19-
inch rack mounting installation. Two brackets for rack-
mounting are supplied. Installing a remote control kit is
similar to installing a voice alarm controller (see section
5.2).
figure 10.1: Front and rear views of the remote control kit
BGM Zone 1
BGM Zone 6
BGM Zone 5
BGM Zone 4
BGM Zone 3
BGM Zone 2
Call Zone 6
Speaker
Power
EMG Ack
EMG Reset
Processor
reset
Network
Call/EMG.
Music/
Spare
Ground
short
Input
Mains
Zone 1~6B
Zone 1~6A
RCP Ext.
Controller/Router
EMG mic
Message
Battery
Call Zone
Indicator 1~6
EMG Zone Indicator 1~6
GND
BGM Zone Indicator 1~6
GND
EMG State Lamp
+
_
-20dB
-6dB
0dB
Disable
Alert Message
Alarm Message
EMG Mic
EMG Switch
Alert Message
Alarm Message
All call
Indicator test
Fault Ack
Fault Reset
Call Zone 1
Call Zone 2
Call Zone 3
Call Zone 4
Call Zone 5
Plena Voice Alarm Remote
Control Kit
LEDS/ LA MP S
200mA Max. input
LED
S/LAMPS
200mA Max. input
LEDS/ LA M PS
200mA Max. input
Call/BGM
Zone selection
GND 24V out
0.2A
5K ohm
< 5mA
24V out
LEDS/ LAMPS input
123456 123456 12
3456
123456123456
EMG mic
External Power Supply
200mA max .
50V DC max.