Bosch Plena - Voice Alarm Controller Components and Functions; Voice Alarm Controller Core Functions

Bosch Security Systems | 2005-10 | 9922 141 10384 en
Plena Voice Alarm System | Software Manual | System en | 13
3 System
3.1 Overview
Use the System window (see figure 3.1) to enter
information about the hardware of which the system
consists.
The buttons at the bottom of the System window are
used to:
• Save changes (Save)
• Cancel changes (Cancel)
• Close the window (Close)
3.2 Voice alarm controller
A Plena Voice Alarm System always contains
1 LBB1990/00 Voice Alarm Controller. It is not
possible to change the number of voice alarm
controllers with the configuration software.
3.3 Voice alarm routers
Use the Number of routers drop-down list to select the
number of LBB1992/00 Voice Alarm Routers in the
system (0 - 9).
3.4 Call stations
Use the Number of call stations drop-down list to select
the number of LBB1956/00 Call Stations in the system
(0 - 8).
3.5 Call station keypads
Use the Number of call station keypads drop-down lists
to select the number of LBB1957/00 Call Station
Keypads that are connected to each call station in the
system (0 - 8).
figure 3.1: System window
Note
The number of the call station is equal to the ID
that is set during the hardware configuration of
the system.
Note
See the Plena Voice Alarm System Installation
and User Instructions (9922 141 1037x) for
more information about the hardware
configuration of the system.