Bosch Security Systems | 2005-10 | 9922 141 10384 en
Plena Voice Alarm System | Software Manual | System en | 14
3.6 Remote control panels
Use the Number of RC panels drop-down list to select
the number of remote controls (LBB1995/00, LBB1996/
00 and LBB1997/00) in the system.
3.7 Control panel extensions
Use the Number of RCP extensions drop-down list to
select the number of remote control extensions
(LBB1998/00 and LBB1999/00) that are connected to
each remote control panel in the system.
3.8 Volume overrides
Put a checkmark in the 3 wires local volume control box
if the system uses 3 wire volume override. If the system
uses 4 wire volume override, make sure that the 3 wires
local volume control box is empty.
3.9 Digital messages
Put a checkmark in the Digital message control only
controls business messages box when the digital-
message volume-control on the rear of the voice alarm
controller controls the sound volume for business
messages only and not emergency messages.
3.10 Emergency all call
Put a checkmark in the EMG all call box if all the zones
in the system are to broadcast a call in the event of an
emergency. All routers forward the emergency message
to all zones in the system. The voice alarm controller
disables all zone buttons on the front panel.
3.11 Alternating broadcasting
Put a checkmark in the Alternating broadcast box to
enable two or more none mergable messages of equal
importance to be broadcast to different zone or zone
groups.
Note
See the Plena Voice Alarm System Installation
and User Instructions (9922 141 1037x) for
more information about the digital message
volume control.
To Next Page
Loading...
