Bosch Plena - 4 Zones; Overview; Introduction; Rename Zones

Bosch Security Systems | 2005-10 | 9922 141 10384 en
Plena Voice Alarm System | Software Manual | Zones en | 15
4Zones
4.1 Overview
Use the Zones window (see figure 4.1) to rename zones
and manage zone groups.
The buttons at the bottom of the Zones window are
used to:
• Save changes (Save)
• Cancel changes (Cancel)
• Close the window (Close)
4.2 Zones
4.2.1 Introduction
All zones have a default name:
• Zones that are connected to the voice alarm
controller are named: Controller Output Z1,
Controller Output Z2, ..., Controller Output Z6.
• Zones that are connected to a voice alarm router are
named: Router N Output Z1, Router N Output Z2, ...,
Router N Output Z6.
4.2.2 Rename zones
Proceed as follows:
1 Select the unit to which the zone is connected from
the Unit drop-down list (Controller, Router 1 - 9).
2 Select the zone output to which the zone is
connected form the Output drop-down list (1 - 6).
3Click in the Name field and change the name of the
zone.
4Click the Save button to save the changes.
4.3 Zone groups
4.3.1 Introduction
Zone groups combine related zones and make it
possible to select multiple zones at the same time. For
example, in a hotel, the following zones could be added
to the zone group Floors: Floor 1, Floor 2, Floor 3 etc.
figure 4.1: Zones window
Note
N is the number of the voice alarm router. This is
equal to the ID that is set during the hardware
configuration of the system.
Note
See the Plena Voice Alarm System Installation
and User Instructions (9922 141 1037x) for
more information about the hardware
configuration of the system.