Bosch Security Systems | 2005-10 | 9922 141 10384 en
Plena Voice Alarm System | Software Manual | Zones en | 16
4.3.2 New zone group
Proceed as follows:
1 Click the New button. A window similar to the one
in figure 4.2 appears.
2 Enter the name of the new zone group in the text
box (e.g. Floors) and push the OK button. The
window disappears and the name of the new zone
group is displayed in the Zones window (see figure
4.3 for an example).
3Click the Add zones button to add zones to the zone
group. A window similar to the one in figure 4.4
appears.
4 Put a checkmark in each box of the zones that must
be added to the zone group:
•The All buttons make it possible to put a
checkmark in all boxes of all zones of a unit.
•The Select All button makes it possible to put a
checkmark in all boxes of all zones in the system.
•The Clear All button clears the checkmarks from
the boxes of all zones in the system.
5Click the Close button to close the Add zones
window. The Zones window (see figure 4.3 for an
example) appears again.
6Click the Save button to save the changes.
figure 4.2: New zone group, step 1
figure 4.3: New zone group, step 2
figure 4.4: New zone, step 3
To Next Page
Loading...
