Bosch Security Systems | 2005-10 | 9922 141 10384 en
Plena Voice Alarm System | Software Manual | Supervision en | 21
5.12 Input supervision
Use the Enable box in the Input Supervision block to
enable and disable input supervision. By default, this
box does not contain a checkmark, which means that
input supervision is disabled. Input supervision can be
configured for:
• Each emergency trigger input in the system
• The mic/line input of the voice alarm controller
Proceed as follows:
1 Click the Setup button in the Input Supervision block
in the Supervision window. A window similar to the
one in figure 5.3 appears.
2 Select the unit to which the inputs are connected
from the Unit drop-down list (for example,
Controller).
3 Put a checkmark in the boxes of the emergency
trigger inputs which must be supervised. Leave the
boxes of the emergency trigger inputs for which
supervision must be disabled empty.
•The Select All button makes it possible to enable
supervision of all emergency trigger inputs that
are connected to the selected unit.
•The Clear All button makes it possible to disable
supervision of all emergency trigger input that
are connected to the selected unit.
figure 5.3: Input supervision
Note
IRefer to 5.3.13.2 of the IUI manual.
To Next Page
Loading...
