Bosch Plena - Create a Message

Bosch Security Systems | 2005-10 | 9922 141 10384 en
Plena Voice Alarm System | Software Manual | Messages en | 29
6.5.2 Create a message
Proceed as follows:
1 Click the New button. A window similar to the one
in figure 6.13 appears.
2 Enter the name of the new message (for example,
Announcements) and click the OK button. The name
of the new message appears in the Edit messages
window (see figure 6.14 for an example).
3Select None from the Template drop-down list to
create a message that is not based on a template.
4 Select the first component of the template from the
Wave file drop-down list in row 1.
5 Select the number of repetitions of the first
component from the Repeat drop-down list in row 1
(1 - 10).
6 Repeat step 4 to step 5 for all other components of
the template (see figure 6.15 for an example).
7Click the Save button to save the changes.
Note
The procedure below does not describe how to
create a mergeable message. See section 6.5.3
for information about creating mergeable
messages.
figure 6.13: Create a message, step 1
figure 6.14: Create a message, step 2
figure 6.15: Create a message, step 6