Bosch Security Systems | 2005-10 | 9922 141 10384 en
Plena Voice Alarm System | Software Manual | Action Programming en | 37
7.3 Router
Use the tabs to select the items for which the actions are
programmed:
• Emergency trigger inputs (EMG trigger)
• Business trigger inputs (Business trigger)
7.4 Call station
7.4.1 Introduction
Use the tabs to select the items for which the actions are
programmed:
• Call station (Main)
• Call station keypads (Keypad).
7. 4 . 2 M ai n
See figure 7.10 for an overview of the Main tab.
Proceed as follows:
1 Select the priority that is assigned to the messages by
the calls station from the Priority drop-down list.
2 Select the message or chime that is played at the start
of the call from the Pre-chime drop-down list.
3 Select the message or chime that is played at the end
of the call from the Post-chime drop-down list.
Note
Programming the actions of the emergency
trigger inputs of a voice alarm router is similar to
programming the actions of the emergency
triggers inputs of a voice alarm router. See
section 7.2.3 for more information.
Note
Programming the actions of the business trigger
inputs of a voice alarm router is similar to
programming the actions of the business
triggers inputs of a voice alarm router. See
section 7.2.4 for more information.
figure 7.10: Main
To Next Page
Loading...
