Bosch Security Systems | 2005-10 | 9922 141 10384 en
Plena Voice Alarm System | Software Manual | Getting Started en | 9
2 Getting started
2.1 Introduction
This chapter describes how to install the configuration
software, connect a PC to an LBB1990/00 Voice Alarm
Controller and start the software. This chapter also
provides information about the user interface of the
configuration software.
2.2 System requirements
The configuration software can be installed on any PC
running the Microsoft Windows 2000 or Microsoft
Windows XP operating system. Make sure that the PC
is working correctly and free of viruses before installing
the software.
2.3 Installation
Proceed as follows:
1 Put the Plena CD-ROM in the CD-ROM drive of the
PC. The CD-ROM starts automatically and a
window similar to the one in figure 2.1 appears. If
the CD-ROM does not start automatically:
•Go to Start > Run.
•Enter X:\index.html. (Replace X with the charac-
ter of the CD-ROM drive.)
2Click Plena Voice Alarm System configuration
software in the left, blue column. A window similar
to the one in figure 2.2 appears.
3Click Plena_VAS_SETUP_0101.EXE. A window
similar to the one in figure 2.3 appears.
figure 2.1: Index
figure 2.2: Set-up file
figure 2.3: File download
To Next Page
Loading...
