Bosch Security Systems | 2004-06 | 9922 141 10371en
Plena Voice Alarm System | Installation and User Instructions | Installation en | 31
4 Installation
4.1 Introduction
The Plena Voice Alarm System is designed for plug-
and-play installation and can be easily configured using
DIP-switches. For more advanced configuration settings,
a PC running the Configuration Software should be
used. Once configured, the PC can be disconnected.
This chapter describes, step by step, the installation
procedure.In order to properly install your Plena Voice
Alarm System, respectively, follow the next steps:
• Check the environmental, electrical and physical
requirements of the installation site (see section 4.2).
• Unpack the equipment (see section 4.3).
• Mount the Plena units (see section 4.5)
• Connect the loudspeakers for the various
loudspeaker zones (see section 4.8).
• Connect the volume overrides (see section 4.9).
• Connect the audio sources: background music
(BGM) and the mic/line input with voice-activated
(VOX) functionality (see section 4.10).
• Connect the trigger outputs (see section 4.12).
• Connect the emergency (EMG) microphone (see
section 4.13).
• Connect the emergency and business trigger inputs
(see section 4.7).
• Connect one or more routers (see section 4.6).
• Connect mains power, back-up power and external
boosters (see section 4.15).
• Connect call stations and call station keypads (see
section 4.14).
4.2 Requirements
Before installing the Plena Voice Alarm System, check,
for each Plena unit, if the environmental, electrical and
physical characteristics of the installation site, meet the
technical specifications that are listed in chapter 8.
4.3 Unpacking
The equipment for your Plena Voice Alarm System is
shipped in cardboard boxes. For the contents of these
boxes, see table 4.1 and table 4.2.
4.4 CD-ROM
The CD-ROM in the box of the voice alarm controller
contains:
• Configuration Software
• Audio tools (e.g. converters)
• Default messages and chimes
•Plena info
•Basic System Manual
Note
Throughout this chapter, whenever a software
configurable function is described, a reference
is made to the Configuration Software Manual
(9922 141 10381) .
Note
Always check if the contents of a shipment
match the listed parts on the shipment
documents.
Caution
To protect the box contents, keep the equipment
boxed prior to installation.
table 4.1: Voice alarm controller, box contents
Description Quantity
Voice alarm controller 1 x
Safety Instructions 1 x
Basic System Manual 1 x
Power cord 1 x
Emergency microphone 1 x
19” rack mounting brackets 2 x
USB cable 1 x
table 4.2: Call station, box contents
Description Quantity
Call station 1 x
Cat-5 cable 1 x
table 4.3: Router, box contents
Description Quantity
Router 1 x
Safety Instructions 1 x
Basic System Manual 1 x
Power cord 1 x
19” rack mounting brackets 2 x
USB cable 1 x
To Next Page
Loading...
