20 | English
2 609 004 157 | (11.5.10) Bosch Power Tools
14 Segment saw blade*
15 Felt ring of the dust extraction*
16 Retaining clip of the dust extraction*
17 Vacuum connection*
18 Dust extraction*
19 Vacuum hose*
*Accessories shown or described are not part of the
standard delivery scope of the product. A complete
overview of accessories can be found in our acces-
sories program.
Technical Data
Noise/Vibration Information
Measured sound values determined according
to EN 60745.
Typically the A-weighted noise levels of the
product are: Sound pressure level 81 dB(A);
Sound power level 92 dB(A). Uncertainty
K=1.8dB.
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Sanding: Vibration emission value a
h
=4 m/s
2
,
uncertainty K=1.5 m/s
2
Cutting with plunge cut saw blade: Vibration
emission value a
h
=20 m/s
2
, uncertainty
K=2.0 m/s
2
Cutting with segmential saw blade: Vibration
emission value a
h
=16 m/s
2
, uncertainty
K=2.5 m/s
2
Scraping: Vibration emission value a
h
=6 m/s
2
,
uncertainty K=1.5 m/s
2
.
The vibration emission level given in this infor-
mation sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another.
It may be used for a preliminary assessment of
exposure.
The declared vibration emission level repre-
sents the main applications of the tool. However
if the tool is used for different applications, with
different accessories or poorly maintained, the
vibration emission may differ. This may signifi-
cantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.
Declaration of Conformity
We declare under our sole responsibility that
the product described under “Technical Data” is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 2006/42/EC.
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 31.03.2010
Multi-function tool PMF 10,8 LI
Article number 3 603 A01 9..
Preselection of orbital
stroke rate z
Rated voltage V= 10.8
No-load speed n
0
min
-1
5000–20000
Oscillation angle,
left/right ° 1.4
Weight according to
EPTA-Procedure
01/2003 kg 0.9
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Dr. Egbert Schneider
Senior Vice President
Engineering
Dr. Eckerhard Strötgen
Head of Product
Certification
OBJ_BUCH-1170-002.book Page 20 Tuesday, May 11, 2010 3:36 PM
To Next Page
Loading...
