English | 17
Bosch Power Tools 1 609 92A 0SE | (30.10.14)
Mounting/Replacing the Application Tool/Accessory
If required, remove an already mounted application tool/
accessory.
For removing the application tool/accessory loosen the screw
10 with the hex key 11 and remove the tool.
Mount the application tool/accessory (e.g. plunge cut saw
blade 9) in such a way on the tool holder 7 that the openings
of the tool engage into the cams of the tool holder.
For a safe and fatigue-free working position it is possible to
position the application tools/accessories in any snap-in posi-
tions on the tool holder. Position the tool in such a way that
the depressed centre points downwards (marking on the tool
is readable from above, see figure on the graphics page).
Use the screw 10 to fasten the application tool/accessory.
Tightly fasten the screw 10 with the hex key 11.
Check the tight seating of the application tool/accesso-
ry. Incorrect or not securely fastened application tools/ac-
cessories can come loose during operation and pose a haz-
ard.
Mounting/Replacing a Sanding Sheet on the Sanding
Plate
The sanding plate 12 is fitted with Velcro backing for quick
and easy fastening of sanding sheets with Velcro adhesion.
Before attaching the sanding sheet 13, free the Velcro back-
ing of the sanding plate 12 from any debris by tapping against
it in order to enable optimum adhesion.
Position the sanding sheet 13 flush alongside one edge of the
sanding plate 12, then lay the sanding sheet onto the sanding
plate and press firmly.
To ensure optimum dust extraction, pay attention that the
punched holes in the sanding sheet match with the holes in
the sanding plate.
To remove the sanding sheet 13, grasp it at one of the tips and
pull it off from the sanding plate 12.
You can use all sanding sheets, fleece pads/polishing cloth
pads of the Delta 93 mm series of Bosch accessory program.
Sanding accessories, such as fleece pads/polishing cloth
pads, are attached to the sanding plate in the same manner.
HM-Riff segment
saw blade
Grouting joints, soft wall
tiles, glass-fibre reinforces
plastic and other abrasive
materials
Cutting and separating close to edges, in corners or hard to
reach areas;
example: removing grouting joints between wall tiles for
repair work, cutting openings in tiles, gypsum boards or
plastic
HM-Riff delta plate
Mortar, concrete remain-
ders, wood, abrasive ma-
terials
Rasping and sanding on hard surfaces;
example: removing mortar or tile adhesive (e.g. when
replacing damaged tiles)
HM-Riff grout and
mortar remover
Mortar, grouting joints,
epoxy resin, glass-fibre re-
inforces plastic and other
abrasive materials
Removing grouting joints from wall and floor tiles as well as
removing mortar and joint adhesive (also in right-angled
corners)
Scraper, rigid
Carpets, coverings Scraping on hard surfaces;
example: removing carpet and tile adhesive
BIM serrated seg-
ment saw blade
Insulation material, insula-
tion panels, floor panels,
sound insulation panels,
cardboard, carpet, rub-
ber, leather
Cutting soft materials
Accessory Material Application
OBJ_BUCH-1170-005.book Page 17 Thursday, October 30, 2014 8:12 AM
To Next Page
Loading...
