18 | English 1 609 929 K84 • 22.12.06
Product Features
The numbering of the product features refers to the
illustration of the machine on the graphics page.
1 Lock-off button for On/Off switch
2 Right handle
3 Spindle lock button
4 Wing bolt for guide rods of parallel guide (2x)*
5 Chip shield
6 Base plate
7 Guide plate
8 Seat for parallel guide rods
9 Step buffer
10 Dust boot
11 Wing bolt for depth stop adjustment
12 Slide with index mark
13 Depth stop
14 Scale for depth-of-cut
15 Left handle
16 Clamping lever for locking of routing depth
17 Scale for depth-of-cut fine adjustment
(POF 1400 ACE)
18 Adjustment knob for depth-of-cut fine adjustment
(POF 1400 ACE)
19 Mark for zeroing
20 Release lever for guide bushing
21 Router bit*
22 On/Off switch
23 Thumbwheel for speed preselection
24 Adjusting screws for step buffer (POF 1200 AE)
25 Tightening nut with collet
26 Open-end spanner, size 19 mm*
27 Extraction hose (Ø 35 mm)*
28 Extraction adapter*
29 Knurled screw for extraction adapter (2x)*
30 Guide rod for parallel guide (2x)*
31 Parallel guide*
32 Centring pin*
33 Wing bolt for centring pin*
34 Curve guide*
35 Router compass/guide-rail adapter*
36 Router compass handle*
37 Wing bolt for coarse adjustment of
router compass (2x)*
38 Wing bolt for fine adjustment of
router compass (1x)*
39 Fine-adjustment knob for router compass*
40 Centring screw*
41 Guide rail*
42 Base spacer
(included in the “router compass” set)*
43 Guide bushing*
*The accessories illustrated or described are not
included as standard delivery.
Technical Data
Noise/Vibration Information
Measured values determined according to
EN 60745.
Typically the A-weighted noise level of the machine is:
sound pressure level 95 dB(A); sound power level
106 dB(A). Uncertainty K=3 dB.
Wear hearing protection!
Overall vibrational value (vector sum of three direc-
tions) determined according to EN 60745:
Vibrational emission value a
h
=6m/s
2
, uncertainty
K=2m/s
2
.
The vibration emission level given in
this information sheet has been
measured in accordance with a standardised test
given in EN 60745 and may be used to compare one
tool with another.
Plunge router POF 1200 AE POF 1400 ACE
Article number 3 603 B6A 0.1 3 603 B6C 7.1
Rated power input W 1200 1400
No-load speed rpm 11000–28000 11000–28000
Speed preselection zz
Constant electronic control – z
Connection for dust extraction zz
Tool holder mm
inch
6/8
¼
6/8
¼
Plunge depth mm 55 55
Weight according to EPTA-Procedure 01/2003 kg 3.4 3.5
Protection class /II /II
The values given are valid for nominal voltages [U] of 230/240 V. For lower voltage and models for specific countries, these
values can vary.
Please observe the article number on the type plate of your machine. The trade names of the individual machines may vary.
WARNING
OBJ_BUCH-323-002.book Page 18 Friday, December 22, 2006 11:28 AM
To Next Page
Loading...
