Bosch Professional GLM 30-23 - Switching On and Off; Measuring Process Overview

12 | English
Switching On and Off
Press the button to switch on the measuring tool.
Press and hold the button to switch off the measuring
tool.
If no button on the measuring tool is pressed for approx.
5min, the measuring tool will switch off automatically to pre-
serve the non-rechargeable batteries.
Measuring Process
When switching on for the first time, the measuring tool will be
in the length measurement function. When switching on every
subsequent time, the measuring tool will be in the measuring
function that was last used.
The rear edge of the measuring tool is always the reference
level for the measurement.
Apply the measuring tool to the point at which you want to
start the measurement (e.g. wall).
Press the button to switch on the laser beam.
Target the target surface with the laser beam.
Briefly press the button again to start the measure-
ment.
The duration of the measurement depends on the distance,
the lighting conditions and the reflective properties of the tar-
get surface. Upon completion of the measurement, the laser
beam will automatically switch off.
The measuring tool must not be moved during a meas-
urement. Therefore, place the measuring tool, as far as
this is possible, against or on a firm stop or supporting surface.
1 609 92A 82K | (20.12.2022) Bosch Power Tools