Bosch Professional GLM 30 - Auto-Sum; Switching sound on;off; Changing the Unit of Measurement

English | 11
u Do not direct the laser beam at persons or animals and do not stare into the laser
beam yourself (even from a distance).
Note: The measured value typically appears within 0.5 seconds and no later than 4
seconds. The duration of the measurement depends on the distance, the lighting condi-
tions and the reflective properties of the target surface. Upon completion of the meas-
urement, the laser beam is automatically switched off.
Auto-Sum (see figureB)
The auto-sum automatically shows the sum of all individual measurements (e.g. useful
for the material calculation).
The auto-sum value is erased as soon as the device is switched off or if it automatically
switches off when no button is pressed after 5 minutes.
The auto-sum is not saved. A subsequent correction of the auto-sum is not possible.
Aim the laser beam at the target surface.
To initiate the measurement, briefly press the measuring button (2).
The current measured value (c) is shown on the bottom line of the
display. The laser beam is switched off.
To switch on the laser beam, briefly press the measuring button (2).
To initiate a further measurement, briefly press the measuring button
(2) again. The current measured value (c) is displayed on the bottom
line. The previous measured value (b) is displayed on the middle line.
The auto-sum (a) (the sum of the current and previous measured val-
ues) is displayed on the top line.
Switching sound on/off (3601K725..)
Switch the measuring tool off.
Press and hold the measuring button (2).
When the cursor is on the desired setting,
release the measuring button (2). After re-
leasing, the measuring tool switches itself
on with the selected setting.
Changing the Unit of Measurement (3601K7257.)
Switch the measuring tool off.
Bosch Power Tools 1 609 92A 5E0 | (29.01.2020)