English | 17
– The front edge of the measuring tool (e.g. when measuring from a table edge)
– The centre of the thread(13) (e.g. for tripod measurements)
To select the reference level, press and hold the [Func] button(7). Use the [+] but-
ton(3) or the [–] button(8) to select the required reference level. The rear edge of the
measuring tool is preset as the reference level every time the measuring tool is switched
on.
Basic settings menu
To enter the basic settings menu (g), press and hold the [Func] button (7).
Select the respective basic setting and choose your setting.
To exit the basic settings menu, press the on/off button (5) [ ].
Display illumination
The display illumination is continuously switched on. When no button is pressed, the dis-
play illumination is dimmed after approx. 20 seconds to preserve the batteries.
Measuring functions
Measuring length
Select the length measurement mode .
To switch on the laser beam, briefly press the measuring button (2) [ ].
To measure, briefly press the measuring button (2) [ ]. The measured value will be
shown at the bottom of the display.
10.602 m
7.951 m
5.301 m
m2.650
Repeat the above steps for each subsequent measurement. The last
measured value is at the bottom of the display, the penultimate meas-
ured value is above it, and so on.
Continuous measurement
In continuous measurement mode, the measuring tool can be moved relative to the tar-
get, during which the measured value will be updated approx. every half a second. You
can, for example, move a desired distance away from a wall while reading off the current
distance at all times.
Select the continuous measurement mode .
To switch on the laser beam, briefly press the measuring button (2) [ ].
Move the measuring tool until the desired distance is shown at the bottom of the display.
Bosch Power Tools 1 609 92A 5G9 | (06.11.2019)
To Next Page
Loading...
