18 | English
Briefly pressing the measuring button (2) [ ] will interrupt the con-
tinuous measurement. The current measured value will be shown at
the bottom of the display. Pressing the measuring button (2) [ ]
once more will start the continuous measurement again.
Continuous measurement automatically switches off after
fiveminutes.
Area measurement
Select the area measurement mode .
Then measure the width and length one after the other as with a length measurement.
The laser beam remains switched on between the two measurements. The distance to be
measured flashes in the indicator for area measurement .
The first measured value is shown at the top of the display.
After the second measurement has been completed, the area will be
automatically calculated and displayed. The end result is shown at
the bottom of the display, while the individual measured values are
shown above it.
Volume measurement
Select the volume measurement mode .
Then measure the width, length and depth one after the other as with a length measure-
ment. The laser beam remains switched on between the three measurements. The dis-
tance to be measured flashes in the indicator for volume measurement .
1474.8 m
12.700 m
3
11.430 m
m10.160
The first measured value is shown at the top of the display.
After the third measurement has been completed, the volume will be
automatically calculated and displayed. The end result is shown at
the bottom of the display, while the individual measured values are
shown above it.
Indirect height measurement / Simple Pythagoras Measurement (see figureE)
The indirect height measurement is used to measure distances that cannot be measured
directly because an obstacle would obstruct the laser beam or no target surface is avail-
able as a reflector. Correct results are achieved only when the right angles required for
the respective measurement are exactly adhered to (Pythagorean Theorem).
1 609 92A 5G9 | (06.11.2019) Bosch Power Tools
To Next Page
Loading...
