English | 21
Changing the unit of measurement ft/m
The default unit of measurement is "m" (metres). Five different units of measurement are
available. Set the appropriate unit of measurement for your purposes.
Setting the language
When switching on the measuring tool for the first time, you will be prompted to set your
preferred language for the display text.
You can change the selected language at any time.
Device information
Here you will find information about the measuring tool, such as the serial number and
software version.
Factory Reset
This function is used to reset the measuring tool to factory settings. After carrying out a
reset, you will be prompted to set your preferred language for the display.
Measuring functions
Help function (see figureC)
To select a measuring function, press the button (2) [Func]. Select the desired measur-
ing function with the button (6) [+] or the button (3) [–].
To start the help function, press the(7) [ ] button. The help function shows the de-
tailed procedure for the selected measuring function.
Measuring length
Select the length measurement mode .
To switch on the laser beam, briefly press the measuring button (5) [ ].
To measure, briefly press the measuring button (5) [ ]. The measured value will be
shown at the bottom of the display.
11.430 m
10.160 m
8.890
0.0°
m
m7.620
Repeat the above steps for each subsequent measurement. The last
measured value is at the bottom of the display, the penultimate meas-
ured value is above it, and so on.
Continuous measurement
In continuous measurement mode, the measuring tool can be moved relative to the tar-
get, during which the measured value will be updated approx. every half a second. You
Bosch Power Tools 1 609 92A 62A | (21.12.2020)
To Next Page
Loading...
