Bosch Professional GLM 50-27 CG - Factory Reset; Measuring Functions; Help Function; Measuring Length

22 | English
Factory Reset
This function is used to reset the measuring tool to factory settings. After carrying out a
reset, you will be prompted to set your preferred language for the display.
Measuring functions
Help function (see figureC)
To select a measuring function, press the button (2) [Func]. Select the desired measur-
ing function with the button (6) [+] or the button (3) [–].
To start the help function, press the(7) [ ] button. The help function shows the de-
tailed procedure for the selected measuring function.
Measuring length
Select the length measurement mode .
To switch on the laser beam, briefly press the measuring button (5) [ ].
To measure, briefly press the measuring button (5) [ ]. The measured value will be
shown at the bottom of the display.
11.430 m
10.160 m
8.890
0.0°
m
m7.620
Repeat the above steps for each subsequent measurement. The last
measured value is at the bottom of the display, the penultimate meas-
ured value is above it, and so on.
Continuous measurement
In continuous measurement mode, the measuring tool can be moved relative to the tar-
get, during which the measured value will be updated approx. every half a second. You
can, for example, move a desired distance away from a wall while reading off the current
distance at all times.
Select continuous measurement . Select one of the following functions:
– Min/max: The smallest and largest measured value are permanently shown on the dis-
play (see figureI).
– Large numbers: The measured value is displayed in an enlarged format for better
legibility (see figureJ).
– Tape measure: The distance will be displayed visually, as with a tape measure (see
figureK). Note: The distance from the marking is shown in the display in the tape
measure function. The reference is not the edge of the measuring tool.
To switch on the laser beam, briefly press the measuring button (5)[ ].
1 609 92A 5YM | (19.01.2021) Bosch Power Tools