Bosch Professional GLM 50-27 CG - Deleting the Memory; Adding;Subtracting Values; Deleting Measured Values

English | 27
The oldest value is located in position 1 in the memory, while the newest value is in posi-
tion 30 (when 30 memory values are available). If a further value is saved, the oldest
value in the memory is always deleted.
Deleting the memory
To delete an individual memory value, select this value(see "Memory value display",
page26). To delete, first press the on/off/back button (8) [ ] and confirm this by
pressing the (2) [Func] button.
To delete all the contents of the memory, press the (7) [ ] button and select the
function. Then press the (6) [+] button and confirm this by pressing the (2) [Func] but-
ton.
Adding/subtracting values
Measured values or end results can be added or subtracted.
Adding values
The following example describes the addition of areas:
Measure an area as described in the "Area measurement" section Area measurement.
143.45 m
2
2
+93.406
m50.039
0.0°
m
2
Press the [+] button(6). The calculated area and the + symbol will be
displayed.
Press the measuring button(5)[ ] to start another area measure-
ment. Measure the area as described in the "Area measurement" sec-
tion Area measurement. Once the second measurement is com-
pleted, the result of the second area measurement is displayed be-
low. To show the end result, press the measuring button(5) [ ] once more.
Note: In the case of a length measurement, the end result is displayed immediately.
To exit addition, press the [Func] button(2).
Subtracting values
To subtract values, press the button (3) [–]. The subsequent steps are the same as for
the section on adding values.
Deleting measured values
Briefly pressing the on/off/back button (8) [ ] will delete the last measured value in all
measuring functions. Repeatedly pressing the on/off/back button (8) [ ] briefly will de-
lete the measured values in reverse order.
Bosch Power Tools 1 609 92A 5YM | (19.01.2021)