Bosch Professional GLM 50 C - Page 13

English | 13
Digital laser measure GLM 50 C GLM 50 C GLM 5000 C
Dimensions 106x45x24mm 106x45x24mm 106x45x24mm
Protection rating IP 54 (dust and
splash-proof)
I)
IP 54 (dust and
splash-proof)
I)
IP 54 (dust and
splash-proof)
I)
Batteries 2x1.5V LR03
(AAA)
2x1.5V LR03
(AAA)
2x1.5V LR03
(AAA)
Rechargeable batteries 2x1.2V HR03
(AAA)
2x1.2V HR03
(AAA)
2x1.2V HR03
(AAA)
Unit of measurement setting m m, ft, in m
Data transmission
Bluetooth® Bluetooth® (4.0
Classic and Low
Energy)
J)
Bluetooth® (4.0
Classic and Low
Energy)
J)
Bluetooth® (4.0
Classic and Low
Energy)
J)
Operating frequency band 2402–2480MHz 2402–2480MHz 2402–2480MHz
Max. transmission power 2.5mW 2.5mW 2.5mW
A) For measurements from the front edge of the measuring tool, this applies for high reflectivity of
the target (e.g. a white-painted wall), weak backlighting and 25°C operating temperature. In ad-
dition, a deviation of ±0.05mm/m must be taken into account.
B) For measurements from the rear edge of the measuring tool, applies to low reflectivity of the tar-
get (e.g. a dark-painted wall), strong backlighting and –10 °C to +45 °C operating temperature.
In addition, a deviation of ±0.15 mm/m must be taken into account.
C) After user calibration at 0 ° and 90 °; An additional grade error of ±0.01 °/degree to 45 ° (max.)
has to be taken into account. The left-hand side of the measuring tool serves as the reference
level for grade measurement.
D) At an operating temperature of 25 °C
E) In continuous measurement mode, the max. operating temperature is +40 °C.
F) An additional error of measuring accuracy of ±0.5 mm has to be taken into account.
G) non-conductive soiling only, whereby occasional temporary conductivity caused by condensa-
tion is expected
H) Bluetooth® deactivated
I) Except battery compartment
J) When using Bluetooth® Low Energy devices, it may not be possible to establish a connection de-
pending on the model and operating system. Bluetooth® devices must support the SPP profile.
The serial number (11) on the type plate is used to clearly identify your measuring tool.
Bosch Power Tools 1 609 92A 5E3 | (30.03.2020)