English | 21
Press the (8) [–] buttonto browse backwards through the saved values.
If there is no value available in the memory, "0.000" is shown at the bottom of the dis-
play and "0" at the top.
The oldest value is located in position 1 in the memory, while the newest value is in posi-
tion 30 (when 30 memory values are available). If a further value is saved, the oldest
value in the memory is always deleted.
Deleting the memory
To delete the contents of the memory, press the (7)[Func] button and select the
memory function [ ]. Then briefly press the on/off button(5) [ ] to delete the dis-
played value.
Press the (4) button and the on/off button (5) simultaneously to delete all measured
values in the memory.
Adding/subtracting values
Measured values or end results can be added or subtracted.
Adding values
The following example describes the addition of areas:
Measure an area as described in the "Area measurement" section (see "Area measure-
ment", page17).
143.45 m
2
2
+93.406
m50.039
0.0°
m
2
Press the [+] button(3). The calculated area and the + symbol will be
displayed.
Press the measuring button(2)[ ] to start another area measure-
ment. Measure the area as described in the "Area measurement" sec-
tion (see "Area measurement", page17). Once the second measure-
ment is completed, the result of the second area measurement is dis-
played below. To show the end result, press the measuring button(2) [ ] once more.
Note: In the case of a length measurement, the end result is displayed immediately.
Subtracting values
To subtract values, press the button (8) [–]. The subsequent steps are the same as for
the section on adding values.
Deleting measured values
Briefly pressing the on/off button (5) [ ] will delete the last measured value in all meas-
uring functions. Repeatedly pressing the on/off button (5) [ ] briefly will delete the
measured values in reverse order.
Bosch Power Tools 1 609 92A 5E3 | (30.03.2020)
To Next Page
Loading...
