Bosch Professional Series - Wiring the Motion Detector; LSN Wiring and Electrical Specifications

16 en | Wiring
Professional Series TriTech AM Motion Detectors
with Anti-mask, LSN
2018.10 | 01 | F.01U.352.414 Reference Manual Bosch Building Technologies
6 Wiring
!
Caution!
Apply power only after you have made and inspected all connections. Do not coil excess
wiring inside the motion detector.
Refer to the wiring illustration for LSN wiring.
A1 B1 A2 B2 SP SP SH
LSN
LSN
A1 = aLSN1
B1 = bLSN1
A2 = aLSN2
B2 = bLSN2
SH =
Specification recommendations
– LSN Bus operating voltage limits are 9-29 V.
– Use no smaller than 0.4 mm (26 AWG) wire.
– Shielded cable is recommended.
Notice!
For all components and connections, only shielded cables are permitted.