English | 11
Bosch Power Tools 2 609 007 741 | (4.11.13)
Hold the machine with a firm grip. High reaction torque
can briefly occur while driving in and loosening screws.
When working with the machine, always hold it firmly
with both hands and provide for a secure stance. The
power tool is guided more secure with both hands.
Secure the workpiece. A workpiece clamped with clamp-
ing devices or in a vice is held more secure than by hand.
Always wait until the machine has come to a complete
stop before placing it down. The tool insert can jam and
lead to loss of control over the power tool.
Products sold in GB only: Your product is fitted with a
BS 1363/A approved electric plug with internal fuse (ASTA
approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place by an author-
ised customer service agent. The replacement plug should
have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains sock-
et elsewhere.
Products sold in AUS and NZ only: Use a residual current de-
vice (RCD) with a rated residual current of 30 mA or less.
Product Description and Specifica-
tions
Read all safety warnings and all instruc-
tions. Failure to follow the warnings and in-
structions may result in electric shock, fire
and/or serious injury.
Intended Use
The machine is intended for impact drilling in brick, concrete
and stone as well as for drilling in wood, metal and plastic. Ma-
chines with electronic control and right/left rotation are also
suitable for screwdriving and thread-cutting.
Product Features
The numbering of the product features refers to the illustra-
tion of the machine on the graphics page.
1 Key type drill chuck
2 “Drilling/Impact Drilling” selector switch
3 Lock-on button for On/Off switch
4 On/Off switch
5 Rotational direction switch
6 Button for depth stop adjustment *
7 Wing bolt for adjustment of auxiliary handle *
8 Auxiliary handle (insulated gripping surface)*
9 Depth stop*
10 Handle (insulated gripping surface)
11 Chuck key
12 Universal bit holder*
13 Screwdriver bit*
*Accessories shown or described are not part of the standard de-
livery scope of the product. A complete overview of accessories
can be found in our accessories program.
Technical Data
Impact Drill PSB 500 RE PSB 530 RE
Article number
3 603 A27 0.. 3 603 A27 0..
Rated power input
W500530
Output power
W260260
No-load speed
min
-1
50 – 3000 50 – 3000
Rated speed
min
-1
2400 2400
Impact rate
min
-1
33000 33000
Rated torque
Nm 1.1 1.1
Torque at max. output power
Nm 7.5 7.5
Right/left rotation
Spindle collar dia.
mm 43 43
Max. drilling dia.
–Concrete
– Steel
– Wood
mm
mm
mm
10
8
25
10
8
25
Chuck clamping range
mm 2 – 13 2–13
Weight according to EPTA-Procedure 01/2003
kg 1.6 1.6
Protection class
/II /II
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary.
OBJ_BUCH-1750-002.book Page 11 Monday, November 4, 2013 3:14 PM
To Next Page
Loading...
