1 609 929 N03 | (10.10.07) Bosch Power Tools
20 | English
Certain dusts, such as oak or beech dust, are
considered as carcinogenic, especially in con-
nection with wood-treatment additives (chro-
mate, wood preservative). Materials contain-
ing asbestos may only be worked by
specialists.
– Use dust extraction whenever possible.
– Provide for good ventilation of the working
place.
– It is recommended to wear a P2 filter-class
respirator.
Observe the relevant regulations in your coun-
try for the materials to be worked.
Operation
Starting Operation
f Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V can
also be operated with 220 V.
Reversing the Rotational Direction
(see figures E–F)
The rotational direction switch 7 is used to re-
verse the rotational direction of the machine.
However, this is not possible with the On/Off
switch 6 actuated.
Right Rotation: For drilling and driving in screws,
push the rotational direction switch 7 left to the
stop.
Left Rotation: For loosening and unscrewing
screws and nuts, press the rotational direction
switch 7 through to the right stop.
Setting the Operating Mode
Drilling and Screwdriving
Set the selector switch 2 to the “Drill-
ing” symbol.
Impact Drilling
Set the selector switch 2 to the “Impact
drilling” symbol.
The selector switch 2 engages noticeably and
can also be actuated with the machine running.
Switching On and Off
To start the machine, press the On/Off switch 6
and keep it depressed.
To lock the pressed On/Off switch 6, press the
lock-on button 5.
To switch off the machine, release the On/Off
switch 6 or when it is locked with the lock-on but-
ton 5, briefly press the On/Off switch 6 and then
release it.
Adjusting the Speed/Impact Frequency
The speed/impact rate of the switched on power
tool can be variably adjusted, depending on how
far the On/Off switch 6 is pressed.
Light pressure on the On/Off switch 6 results in
low speed/impact rate. Further pressure on the
switch increases the speed/impact rate.
Preselecting the Speed/Impact Frequency
(see figure G) (PSB 700 RE/PSB 700 RES)
With the thumbwheel for speed preselection 15,
the required speed/impact frequency can be
preselected even during operation.
The required speed/impact frequency depends
on the material and the working conditions, and
can be determined through practical testing.
Electronic Torque Limitation/Speed Preselec-
tion (Torque Control) (PSB 1000 RPE)
Drilling with speed preselection: Set
the selector switch 4 to the “Drilling”
symbol. The required speed can be
selected with the thumbwheel 3; it
can also be adjusted during opera-
tion.
Screwdriving with torque limitation:
Set the selector switch 4 to the
“Screwdriving” symbol. The effective
torque at the drill spindle can be var-
iable adjusted with the thumbwheel
3 during operation:
I=low torque, III=high torque.
The maximum speed is automatically adapted to
the adjusted torque.
OBJ_BUCH-530-001.book Page 20 Wednesday, October 10, 2007 10:49 AM
To Next Page
Loading...
