English | 21
Bosch Power Tools 1 609 929 S60 | (21.7.09)
Selecting the Sanding Sheet
Depending on the material to be worked and the
required rate of material removal, different
sanding sheets are available:
For reworking or polishing, especially of metal
and stone, use fleece/polishing cloth pad.
Depending on the desired surface quality of the
workpiece, different fleece types or polishing
cloth pads are to be used.
Replacing the Sanding Plate
(see figure H)
n Slide the SDS button for release of the sand-
ing plate 23 all the way to the right.
o Remove the sanding plate 24.
p Guide the sanding plate 24 from below
against the sanding plate holder and firmly
press them together.
q Slide the SDS button for release of the sand-
ing plate 23 all the way to the left.
If, e. g., the front tip of the sanding sheet is
worn, you can also remove the complete sand-
ing plate and reattach it turned by 120°.
Specialty Sanding Plates
You can replace the supplied sanding plate 24
with a specialty sanding plate, which is available
as an accessory.
The specialty sanding plate is attached in the
same manner as the one supplied.
Attach and remove the respective sanding
sheets in the same manner as when changing
original sanding sheets.
Pad Extender (see figure I)
With the pad extender 26 you can sand surfaces
that are difficult to access, such as sills on win-
dows, cabinets or doors.
Pad Extender, Narrow (see figure J)
With the narrow pad extender 28 you can sand
narrow openings, slots and passages.
Pad Extender, Narrow Rounded (see figure K)
The narrow rounded pad extender 29 allows you
to sand curved and hollow areas or surfaces that
are curved inward, such as on furniture, rails or
heating radiators.
Operation
Starting Operation
f Observe the correct mains voltage! The
voltage of the power source must agree
with the voltage specified on the nameplate
of the vacuum cleaner. Vacuum cleaners
marked with 230 V can also be connected to
220 V.
Switching On and Off
f Switch the vacuum cleaner on when the
sander is set at “0”. After switching off,
wait until the sander has come to a stand-
still before placing it down. The sander can
move unintentionally.
f Completely unreel the cable before putting
the vacuum cleaner into operation. The ca-
ble can heat up.
Grain size
For the working of all
wooden materials
40—180
For coarse-sanding, e. g.
of rough, unplaned beams
and boards
coarse 40
For face sanding and plan-
ing small irregularities
medium 80, 120
For finish and fine sanding
of hard woods
fine 180
For the working of
paint/enamel coats or
primers and fillers
40—180
For sanding off paint coarse 40
For sanding primer medium 80, 120
For final sanding of prim-
ers before coating
fine 180
OBJ_BUCH-39-004.book Page 21 Tuesday, July 21, 2009 2:15 PM
To Next Page
Loading...
