English - 1
1
Torque setting ring
2
Keyless chuck
3
Rotational direction switch
4
On/Off switch
5
Battery
6
Battery unlocking button
7
Screwdriver attachment (bit)
8
Universal bit holder
Not all the illustrated or described accessories are
included as standard delivery.
The machine is intended for the screwing in and
loosening of screws and for drilling in wood,
metal, ceramics and plastic.
Measured values determined according to
EN 50 144.
The A-weighted sound pressure level of the tool
is less than 70 dB (A).
The noise level when working can exceed
85 dB (A).
Wear ear protection!
The typical hand-arm vibration is below 2.5 m/s
2
.
Working safely with this ma-
chine is possible only when the
operating and safety information
is read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety notes in the safety
notes section must be observed.
■
Wear safety glasses.
■
If you have long hair, wear a protective hairnet.
Work only with close-fitting clothes.
■
Before each use, check the machine and bat-
tery. If damage is detected, do not use the ma-
chine. Have repairs performed only by a qual-
ified technician. Never open the machine your-
self.
■
Before any work on the machine itself (e. g.
maintenance, tool change, etc.) as well as
when transporting and storing it, always
set the rotational direction switch to the
middle position.
Otherwise an injury may oc-
cur when unintentionally pressing the On/Off
switch.
■
Before using, make sure the battery fits se-
curely inside the machine.
■
Do not load the machine so heavily that it
comes to a standstill.
■
Always hold the machine securely because
strong reaction moments can occur as a result
of the driving-in process.
Tool Specifications
Battery-Powered Screwdriver PSR 960 PSR 1200 PSR 1440
Part number 0 603 944 6.. 0 603 944 5.. 0 603 944 4..
Idling speed [rpm] 0–550 0–700 0–700
Torque, max. [Nm] 12 15 15
max. drilling Ø
Steel [mm] 8 10 10
Soft wood [mm] 14 20 25
Hard wood [mm] 8 10 10
Screw diameter, max. [mm] 6 8 8
Drill spindle threads 3/8" 3/8" 3/8"
Weight with battery, approx. [kg] 1.3 1.4 1.5
Battery NiCd NiCd NiCd
Temperature monitor NTC NTC NTC
Rated voltage [V=] 9.6 12 14.4
Weight [kg] 0.4 0.5 0.6
Please observe the order number of your machine. The trade names of the individual machines may vary.
Operating Controls
Intended Use
Noise/Vibration Information
For Your Safety
2 609 140 210 - Buch Seite 1 Montag, 18. November 2002 8:07 08
3 • 2 609 140 210 • TMS • 13.11.02
To Next Page
Loading...
