2 609 002 498 | (7.1.08) Bosch Power Tools
18 | English
Technical Data
Declaration of Conformity
We declare under our sole responsibility that the
product described under “Technical Data” is in
conformity with the following standards or
standardization documents: EN 60745 according
to the provisions of the directives 2004/108/EC,
98/37/EC (until Dec. 28, 2009), 2006/42/EC
(from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
06.12.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Noise/Vibration Information
Measured values determined according to
EN 60745.
Typically the A-weighted sound pressure level of
the product is less than 70 dB(A). Uncertainty
K=3dB.
The noise level when working can exceed
80 dB(A).
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Drilling into metal: Vibration emission value
a
h
<2.5 m/s
2
, Uncertainty K =1.5 m/s
2
,
Screwdriving: Vibration emission value
a
h
<2.5 m/s
2
, Uncertainty K =1.5 m/s
2
.
The vibration emission level given in this informa-
tion sheet has been measured in accordance
with a standardised test given in EN 60745 and
may be used to compare one tool with another. It
may be used for a preliminary assessment of ex-
posure.
The declared vibration emission level represents
the main applications of the tool. However if the
tool is used for different applications, with differ-
ent accessories or poorly maintained, the vibra-
tion emission may differ. This may significantly
increase the exposure level over the total work-
ing period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total
working period.
Identify additional safety measures to protect the
operator from the effects of vibration such as:
maintain the tool and the accessories, keep the
hands warm, organisation of work patterns.
Assembly
Battery Charging (see figure A)
f Use only the battery chargers listed on the
accessories page. Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
Cordless Screwdriver PSR 14,4 LI
Article number
3 603 J54 1..
Rated voltage
V= 14.4
No-load speed
rpm 0–450
Max. torque for hard/soft
screwdriving application
according to ISO 5393
Nm 28/12
Max. screw dia.
mm 8
Max. drilling dia.
– Steel
– Wood
mm
mm
10
25
Chuck clamping range
mm 0–10
Weight according to
EPTA-Procedure 01/2003
kg 1.15
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Dr. Egbert Schneider
Senior Vice President
Engineering
Dr. Eckerhard Strötgen
Head of Product
Certification
OBJ_BUCH-614-001.book Page 18 Monday, January 7, 2008 1:54 PM
To Next Page
Loading...
