Then push the base plate (6) towards the saw blade (9) as far as it will go.
Slide the bracket (17) so that the guide roller (8) fits against the back of the saw blade. Precise cuts are only
possible when the guide roller fits closely against the back of the saw blade.
Retighten the screw (18).
Cut Control for mitre cuts
To enable you to track the cutting line (Cut Control), the viewing window for Cut Control (10) has a mark (20) for right-
angled cuts at 0° and a mark (21) for rightward- and leftward-slanting mitre cuts at 45° according to the scale (19).
The cut mark for mitre angles between 0° and 45° is proportional. It can also be marked on the viewing window for
Cut Control (10) using a non-permanent marker and easily removed again. We recommend making a test cut for
precise results.
Moving the base plate (see figure E)
You can move the base plate (6) back for sawing close to edges.
Insert a saw blade (9).
Loosen the screw (18) and push the base plate (6) towards the extraction outlet (5) as far as it will go.
Slide the bracket (17) so that the guide roller (8) fits against the back of the saw blade. Precise cuts are only possible
when the guide roller fits closely against the back of the saw blade.
Retighten the screw (18).
Sawing with an offset base plate (6) is only possible with a mitre angle of 0°. In addition, Cut Control must not be
used with the base (11) or the anti-splinter guard (15).
Sawdust blower device
The cutting line can be kept clear of chips using the airflow from the sawdust blower device.
To switch on the sawdust blower device: When working with high material removal in wood, plastic and other similar
materials, push the switch (7) towards the extraction outlet.
To switch off the sawdust blower device: When working in metal and with a dust extraction system connected, push
the switch (7) towards the saw blade.
To Next Page
Loading...
