18
Router Table Assembly
ATTACHING THE FENCE TO THE TABLE
(Fig. 12)
1. From underneath the table, slide two 1/4-20 x 1
3
⁄4″
carriage bolts (34) up through the slots in the
tabletop and the holes in the bottom of the fence.
Slide a washer (26) onto each bolt and loosely
attach a large clamping knob (14) onto each bolt.
2. Make sure that the fence assembly slides smoothly
from front to back.
NOTE: Use the scale on the tabletop as a guide
when aligning the fence for routing operations. Once
the fence is positioned and aligned correctly, tighten
the clamping knobs SECURELY.
INSTALLING THE FENCE
14
FIG. 12
26
34
To Next Page
Loading...
