Bosch Rexroth 4WS2EM 10 Series - Personal protective equipment; Obligations of the machine end-user

Safety instructions 15/48
RE29583-XL-B/09.20, 4WS2EM 10...XL..., BoschRexrothAG
Contact with salt water leads to increased corrosion on the valve. This may
chemically corrode and damage individual valve mounting and plug screws.
Therefore, take suitable corrosion protection measures.
2.7 Personal protective equipment
The machine end-user must provide the personal protective equipment
(such as gloves, working shoes, safety goggles, working clothes, etc...).
2.8 Obligations of the machine end-user
The machine end-user is obliged to check in the order confirmation whether the
supplied valve complies with the required category and the corresponding zone.
The machine end-user of the BoschRexroth valve is responsible that
• the valve is only being used according to the intended use as defined in these
operating instructions.
• the valve is only stored, operated and maintained according to the technical data,
operating and environmental conditions indicated in "Datasheet29583-XL", in
particular that the limit values indicated in "Datasheet29583-XL" are not exceeded.
• the applicable provisions, rules and directives on explosion protection are
complied with.
• the operating personnel are instructed at regular intervals.
• a danger zone is marked, if required.
• the safety measures for their specific area of application of the valve are complied
with.