22/48 Transport and storage
BoschRexrothAG, 4WS2EM 10...XL..., RE29583-XL-B/09.20
6 Transport and storage
6.1 Valve transport
CAUTION
Danger of damage to property and personal injury!
With improper transport, the valve can fall and lead to damage and/or injury since
the parts are e.g.sharp-edged, oily, instable, loose or bulky.
▶ Use the original packaging for transport.
▶ Use personal protective equipment (such as gloves, working shoes,
safetygoggles, working clothes, etc.).
▶ Comply with the national laws and regulations regarding occupational health
and safety and transport.
▶ Do not transportthe valve using components with little stability, e.g.cables.
Sharp edges!
Danger of cut injury!
▶ Wear suitable protective equipment for the transportof the safety valve.
Further information regarding the transportis available from BoschRexroth,
seechapter16.1 "List of addresses".
Report any transport damage to your responsible sales contact person within
one week. The addresses of the sales subsidiaries can be found on the Internet
on: http:/www.boschrexroth.com/adressen
6.2 Storing the hydraulic valve
Hydraulic valves are delivered in an unobjectionable state.
For the transportation and storage of the product, always observe the
environmental conditions specified in "Datasheet29583-XL". Improper storage
may damage the valve.
Hydraulic valves can be stored for up to 12 months under the following conditions:
▶ Ensure astorage temperature range of +5...+40°C.
▶ The relative air humidity must not exceed 65%.
▶ The storage rooms must provide 100% UV protection.
▶ No ozone formation may occur near the storage facility.
▶ Do not store the valve outdoors but in awell-ventilated room.
▶ The storage facilities must be free from etching substances and gases.
▶ Protect the valve against humidity, particularly ground humidity. Store the valve
on ashelf or on apallet.
▶ Store the valve protected against impacts and sliding and do not stack it.
To Next Page
Loading...
