Transport and storage 23/48
RE29583-XL-B/09.20, 4WS2EM 10...XL..., BoschRexrothAG
▶ Store the valve in the original packaging or similar packaging in order to protect it
from dust and dirt.
▶ All connections on the hydraulic valve must be closed with closing elements.
▶ After opening the transportpackaging, it must be closed properly again for
storage. Use the original packaging for storage.
1. Check the complete valve for damage and corrosion prior to installation.
2. In atest run, check the valve for correct function and leak-tightness.
After expiry of the maximum storage time, we recommend having the valve
checked by your competent Rexroth service. In case of questions regarding
spare parts, please contact the Rexroth service responsible for your valve,
seechapter10.7 "Spare parts".
If adismounted valve is to be stored, it has to be preserved for protection against
corrosion for the duration of storage.
Rexroth recommends the following procedure:
1. Clean the valve, seechapter10.1 "Cleaning and care".
2. Close all connections so that they are airtight.
3. Moisten the unpainted external metal surfaces of the valve using an appropriate
corrosion protection agent.
4. Pack the valve with adesiccant air-tightly in corrosion protection film.
5. Store the valve protected against impacts.
▶ In each case, please observe any applicable provisions and laws regarding the
handling of substances hazardous to water or to health.
Procedure after expiry of
the maximum storage time
of 12 months
Following disassembly
To Next Page
Loading...
