Bosch Rexroth BODAS DSA/12 - General Safety Instructions

RE95290-01-B/2021-09-13, BoschRexrothAG
Safety instructions | BODAS speed sensors 11/36
System developments, installations and commissioning of electronic systems for
controlling hydraulic drives must only be carried out by trained and experienced
specialists who are sufficiently familiar with both the components used and the
complete system.
BoschRexroth offers you measures supporting training in specific areas.
You can find an overview of the training contents on the Internet at:
www.boschrexroth.com/training.
2.5 General safety instructions
• Observe the country-specific accident prevention and environmental protection
regulations.
• Observe the safety regulations of the country in which the product is used/operated.
• Use Rexroth products only when they are in good working order.
• Do not install, operate, disassemble or maintain Rexroth products if under
the influence of alcohol, drugs or medication that may affect your reaction time.
• Only use approved accessories and original spare parts from Rexroth in order to
exclude hazards to persons due to unsuitable spare parts.
• Observe the technical data and ambient conditions specified in the product
documentation.
• If unsuitable products are installed or used in applications that are of relevance
to safety, unexpected operating conditions may occur in the application,
which could result in personal injury or property damage. For this reason, only use
the product in safety-relevant applications if this use is expressly indicated and
approved in the product documentation, e.g.in safety-related parts of acontrol
system (functional safety).
• Only commission the product if it has been determined that the end product
(e.g.machinery/system) in which the Rexroth products are installed complies
with the country-specific provisions, safety regulations and standards for the
application.
• Use tools appropriate for the work being performed and wear appropriate
protective clothing to prevent punctures and cuts (e.g.when removing protective
covers, disassembly).
• The speed sensor contains electronic components and may thus be damaged by
electrostatic discharge. Comply with the handling regulations for electronically
sensitive components, see respective data sheet (Table 1 "Required and
supplementary documentation" on page 5)
• The proposed circuits do not imply any technical liability for the system or the
machine on the part of BoschRexroth.
• Opening the sensor or carrying out modifications to or repairs on the sensor
is prohibited. Modifications to or repairs on the wiring can lead to dangerous
malfunctions.
• You may open connections in the hydraulic system only if the system is
depressurized.
• The sensor may only be installed/disassembled in ade-energized and
depressurized state.
• Make sure that nobody is in the machine’s danger zone.