Bosch Rexroth BODAS DSA/12 - Electrically Connecting the Speed Sensor

RE95290-01-B/2021-09-13, BoschRexrothAG
Installation | BODAS speed sensors 29/36
7.3.5 Electrically connecting the speed sensor
1. Make sure that the connector of the sensor and the mating connector of the wire
harness match; the pin assignment can be found in the respective data sheet,
see Table 1 "Required and supplementary documentation" on page 5.
2. Make sure that the mating connector of the wire harness is in de-energized
condition.
3. Connect the mating connector of the wiring harness to the sensor connector
until it engages noticeably and observe the correct plug-in position.