8/36 BODAS speed sensors | Safety instructions
BoschRexrothAG, RE95290-01-B/2021-09-13
2 Safety instructions
2.1 About this chapter
The product has been manufactured in accordance with generally accepted
engineering standards. There is still, however, adanger of personal injury or
property damage if this chapter and the safety instructions in this documentation are
not observed.
▶ Read this documentation completely and thoroughly before working with
the product.
▶ Keep this documentation in alocation where it is accessible to all users
at all times.
▶ Always include the required documentation when passing the product
on to third parties.
2.2 Intended use
The sensor is intended as acomponent for application in mobile working machines.
The sensor may only be commissioned after it has been installed in the
machine/system for which it is intended and the safety of the entire system has been
established in accordance with the Machinery Directive.
The sensors have the following functions/properties:
Table 6: Functions/properties
Functions/properties
DSA/12 DSA/20 DSM/10 DSM/20 DST/10 HDD/20
Speed sensing x x x x x x
Detection of the direction of rotation x x x x x x
additional diagnostic information x x
Temperature measurement x x
2 wire current interface x x x
redundant voltage output x x x
▶ Generally, the sensor must be operated within the operating ranges specified and
approved in the respective datasheet, see Table 1 "Required and supplementary
documentation" on page 5, particularly with regard to voltage, temperature,
vibration, shock and other described environmental influences.
▶ Its use outside of these specified and approved boundary conditions may result
in danger to life and/or cause damage to components which could result in
sequential damage to the mobile working machine.
▶ Serious personal injury and/or damage to property may occur in case of
non-compliance with the appropriate regulations.
▶ Observe the corresponding IP protection class.
To Next Page
Loading...
