Bosch Rexroth CS660 - (4 knob) Spreader + 3 Boom Anti-icing + Cross Conveyor; Selecting System Profiles; Joystick Operation Controls

11/27
Bosch Rexroth Canada I March 2021 ı Revision 3.0
STEP 1
Ensure system safe to run
Manual Gate:
Manually adjust gate &
enter the gate position
Readback Gate:
Manually adjust gate (no
need to enter)
Continue to next step
Stop to abort
Material Names:
Select name from list
Click to popup keypad
Enter to save
Solid Rates:
Setpoints for 9 conveyor
knob positions
Unit of Solid Rate:
Kg/km or Lb/mi
Cal Gate:
Gate position used for
material calibration
2.5 Material Setup & Calibration
2.5.1 Solid Material Setup
Tap on the solid material icon to configure materials desired. It allows to set up to 4 different
solid materials, and 9 application rates and a blast rate for each material.
2.5.2 Solid Material Calibration – Manual or Readback Gate
1. Prepare a container to catch material discharged
2. Make sure that sufficient material in the hopper and the system is safe to run.
3. Press ‘START’ to proceed and follow the instruction on the screen
Note: Press “STOP” button to stop the process anytime during calibration.