IndraControl L40 Connections and Interfaces 7-7
DOK-CONTRL-IC*L40*****-PR02-EN-P
U
M
U
S
U
L
U
ANA
GNDL
PWR IN
IndraControl L40 Rexroth Inline
U
LS
U
LS
24 PWR IN 24 SEG/F
Spannung_ULS.FH9
L: PWR IN Voltage module at the IndraControl L40
R-IL 24 PWR IN Power terminal
R-IL 24 SEG/F Segment terminal with fuse
Fig. 7-10:Inline supply and analog circuit
For wiring instructions, please refer to the chapter on "Electric Installation"
on page 8-8 and following pages.
7.3 Digital Inputs and Outputs
Address Assignment of Inputs and Outputs
The eight digital inputs and outputs that are available at slots 1 through 4
of the IndraControl L40 (from left to right) are assigned to light-emitting
diodes and bit addresses according to the following table:
Eight digital inputs Eight digital outputs
Slot 1234
Status LED 1234123412341234
Byte IX0.0 – 0.7 (default) QX0.0 – 0.7 (default)Byte-bit
view
Bit 0123456701234567
Terminal point
(signal)
1.1 2.1 1.4 2.4 1.1 2.1 1.4 2.4 1.1 2.1 1.4 2.4 1.1 2.1 1.4 2.4
Terminal point
(24 V)
1.22.21.32.31.22.21.32.3--------
Module
Terminal point
(last ground)
--------1.22.21.32.31.22.21.32.3
Fig. 7-11: Address assignment of inputs and outputs
IAS COMPONENTS www.ias-components.com info@ias-components.com
To Next Page
Loading...
