Bosch Rexroth IndraControl L40 - Fig. 9-5: Connector Coding

9-4 Structure of the Rexroth Inline Terminals IndraControl L40
DOK-CONTRL-IC*L40*****-PR02-EN-P
Important: Place only black connectors on supply terminals! The
terminal point jumpering ensures that the potential is
transmitted (if this feature is provided) via the
jumpering in the connector and not via the module
board.
It is possible to prevent the mismatching of connectors by coding socket
and connector.
1
1
1
2
1
A
1
C
1
B
Steckerkodierung.FH9
Fig. 9-5: Connector coding
• For this purpose, put a coding profile into the coding keyway in the
socket (1) and pull it off the small plate (2) by rotation (Fig. 9-5, Fig. A).
• Use nippers to cut the respective coding tab off the connector
(Fig. 9-5, Fig. B).
Now, only socket and connector of the same coding fit together
(Fig. 9-5 /C).
Connector Coding
IAS COMPONENTS www.ias-components.com info@ias-components.com