R911310381 / 02 | Rexroth IndraControl VCP 20 Electric Drives and Controls | Bosch Rexroth AG 6-3
Display and Operating Components
The key 3 and YZ% is used to edit data in the editor. The characters Y,
Z and % can be entered if the system variable Shift or ShiftCase is con-
figured.
The key 4 and JKL is used to edit data in the editor. The characters J,
K and L can be entered if the system variable Shift or ShiftCase is con-
figured.
The key 5 and MNO is used to edit data in the editor. The characters M,
N and O can be entered if the system variable Shift or ShiftCase is con-
figured.
The key 6 and PQR is used to edit data in the editor. The characters P,
Q and R can be entered if the system variable Shift or ShiftCase is con-
figured.
The key 7 and ABC is used to edit data in the editor. The characters A,
B and C can be entered if the system variable Shift or ShiftCase is con-
figured.
The key 8 and DEF is used to edit data in the editor. The characters D,
E and F can be entered if the system variable Shift or ShiftCase is con-
figured.
The key 9 and GHI is used to edit data in the editor. The characters G,
H and I can be entered if the system variable Shift or ShiftCase is con-
figured.
The key Decimal point and :?! is used to edit data in the editor. The
characters :, ? and ! can be entered if the system variable Shift or Shift-
Case is configured.
The key: Plus and <=> is used to edit data in the editor. The characters
<, = and > can be entered if the system variable Shift or ShiftCase is
configured.
The key: Minus and \*/ is used to edit data in the editor. The characters
\, * and / can be entered if the system variable Shift or ShiftCase is con-
figured.
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com
To Next Page
Loading...
