Bosch Rexroth IndraControl VCP 20.2 - Function Keys; Slide-In Identification Strips for the Function Keys; Fig. 6-2: Set of Slide-In Identifications Strips

R911310381 / 02 | Rexroth IndraControl VCP 20 Electric Drives and Controls | Bosch Rexroth AG 6-5
Display and Operating Components
6.2.4 Function Keys
6.2.4.1 Slide-in Identification Strips for the Function Keys
The identifications strips can be replaced when the operating device is
built-in or removed. Inserting the strip from the rear side of the front
plate does not influence the specified seal of the operator terminal. A
set of identification strips is supplied with the operator terminal.
For the labeling use:
Fig. 6-2: Set of slide-in identifications strips
The function of function keys can be assigned as required (softkey func-
tionality). The function keys can optionally be used as direct selection
keys for menu control or to trigger a function in the controller.
Single pieces, prototypes Label with a water-resistant pen
Small series Copying foil (thickness <= 70 µm) with
laser print
Large series Customer-specific labeled identification
strips
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com