7-2 Bosch Rexroth AG | Electric Drives and Controls Rexroth IndraControl VCP 20 | R911310381 / 02
Interfaces
7.1 Standard Interfaces
7.1.1 Ethernet (X5)
A 10/100 Base-T Ethernet interface is located on the side of the operat-
ing device.
7.1.1.1 Pin Assignment
Connector in the small operator terminal: RJ45 female connector.
7.1.1.2 Cable
Pin Designation Function
1 Tx+ Transmitted Data, Positive Polarity
2 Tx- Transmitted Data, Negative Polarity
3 Rx+ Received Data, Positive Polarity
4 n.c. Not connected
5 n.c. Not Connected
6 Rx- Received Data, Negative Polarity
7 n.c. Not Connected
8 n.c. Not Connected
Fig. 7-2: Pin assignment of the Ethernet interface
A twisted-pair cable of category 6+ (CAT 6+) must be used. The maxi-
mum cable length is 100 m (328 feet).
See the IEEE 802.3 standard for further information.
Courtesy of CMA/Flodyne/Hydradyne ▪ Motion Control ▪ Hydraulic ▪ Pneumatic ▪ Electrical ▪ Mechanical ▪ (800) 426-5480 ▪ www.cmafh.com
To Next Page
Loading...
