Bosch Rexroth IndraControl VCP 25 - Default Contrast; Default Brightness Setting; Character Attributes; Fonts

6-2 Bosch Rexroth AG | Electric Drives and Controls Rexroth IndraControl VCP 25 | R911299720 / 02
Display and Operating Components
6.1.2 Default Contrast / Default Brightness Setting
If the contrast / brightness setting is such that it is no longer possible to
read the masks, you can use the user mode switch to reset the contrast
/ brightness to the default value.
To restore the default contrast / default brightness:
1. Switch the device off.
2. Set the switches S1 and S4 of the user mode switch to ON.
3. Switch the device on again.
4. When the warning appears, switch the device off again.
5. Set switch S4 to OFF.
6. Then switch the device on again.
The application will not be lost.
6.1.3 Character Attributes
The following character attributes can be displayed on the device:
–Normal
– Underlined
– Foreground / background color
6.1.4 Fonts
You are able to use the Windows character sets. Further you can use
the font "Normal" and the font "Zoom" or create and use your own char-
acter sets.
For the table with the switch positions of the user mode switch, see
chapter "User Mode Switch".
The switch position for the default contrast / brightness is identical with
the "Activate download via hardware". The contrast / brightness is reset
before a corresponding message is displayed. The warning will be dis-
played in a legible manner.