Fig. 10-20: Foil shield removed
3. Fastening the cable with EMC shielding clamp.
Ensure that the CDI cable is not crimped when connecting the
shielding to the equipotential bonding. Use an EMC shielding clamp
suitable for the cable diameter. Crimping the cable impairs the elec-
trical properties of the CDI cable. Avoid mechanical stress (tensile,
compressive) on the plug.
Fig. 10-21: Example: Attached shielding clamp
More shielding clamps:
①
Company Ikotec
② Company Phoenix Contact
Fig. 10-22: Shielding clamps
11 Commissioning
The product can be used directly. No configuration is required.
For software descriptions, refer to the project planning manual "IndraControl V-
Devices Operating Systems" (see tab. 1-1 "Related documents" on page 2). The
following functions are described in this project planning manual:
Control Cabinet PC
Bosch Rexroth AG
Commissioning
DOK-SUPPL*-VPB*40.3***-IT05-EN-P
39/57
To Next Page
Loading...
