3.4 Explaining the signal alert symbol on the device
If this symbol is on your device, you have to observe the documentation
on the device. The respective documentation informs on the type of
hazard as well as the steps required to avoid this hazard.
4 Intended use
The control cabinet PC IndraControl VPB 40.4 provides - together with an
operator display (e.g. IndraControl VDP xx.3) - a PC-based operator terminal
that can also have a control functionality. This functionality depends on the
application and on the configuration.
Risk of damaging the device if not expressly
stated accessories, mounting parts and other
components, cables, lines and software and
firmware are used
The control cabinet PC IndraControl VPB 40.4 may only be used with the
accessories and mounting parts listed in this documentation. Components that
are not expressly mentioned must neither be attached nor connected. The same
applies to cables and lines.
Only to be operated with the component configurations and combinations
expressly defined and with the software and firmware specified in the
corresponding functional description.
Typical areas of application of the control cabinet PC IndraControl VPB 40.4:
● Handling and assembly systems
● Food and packaging machines
● Printing and paper converting machines
● Machine tools
● Wood working machines
The control cabinet PC IndraControl VPB 40.4 may only be operated under the
mounting and installation conditions, in the position of application and under
the ambient conditions (temperature, degree of protection, humidity, EMC, etc.)
specified in this documentation.
IndraControl VPB 40.4
5/57
Intended use
R911376309_Edition 02 Bosch Rexroth AG
To Next Page
Loading...
