②: The specified 3.8 A are applied for the operation without further
5 V consumers (e. g. PCI plug-in cards). Limit the operation with
further 5 V consumers to a total power consumption of 1.5 A to
prevent that the internal power supply unit switches off accidentally.
If the maximum power consumption has been exceeded, a message
is displayed that the USB devices are disabled. The USB devices
operate again as soon as less than 500 mA current is consumed from
a USB 2.0 socket or less than 900 mA from a USB 3.0 socket.
Additionally, the USB error message in the taskbar has to be
acknowledged manually.
Connect only USB devices which comply with the noise immunity
according to the EMC directive (industrial environments). This
avoids an unintended switch-off of the control cabinet PC.
If there is an mPCIe module internally, a USB 2.0 device connected
to XUSB5 does not operate anymore. A possibly connected USB 3.0
device is still functioning.
9.4 Ethernet interfaces XETH1 and XETH2
The control cabinet PC can be connected to an Ethernet network via the
Ethernet interfaces XETH1 and EXTH2.
The LAN assignment under Windows to the XLAN connections at the device is
set as follows by default:
Labeling under Windows 7
Labeling at the device
Local Area Connection XETH1
Local Area Connection 2 XETH2
Labeling under Windows 10
Ethernet XETH1
Ethernet 2 XETH2
RJ45, socket, 8-pin
Type: Ethernet 10 Base-T, 100 Base-T, 1000 Base-T
Cable length: 100 m max.
Transmission rate: 10, 100 or 1000 MBit/s
9.5 DisplayPort XDP
At the DisplayPort (XDP), a monitor with DisplayPort interface, a DVI monitor or
an HDMI monitor can be connected (via adapter).
18/57
Interfaces
IndraControl VPB 40.4
Bosch Rexroth AG R911376309_Edition 02
To Next Page
Loading...
